Troubleshooting - Sherwood S9 Instrucciones De Funcionamiento

Troubleshooting

If you experience any of the following difficulties while using the system, use this troubleshooting
guide to help remedy the problem before requesting servicing. Should any problem persist, consult
your nearest authorized dealer or authorized independent company.
If the unit does not operate normally due to external influence such as static electricity, disconnect
the power plug from the outlet and insert again to return to normal operating conditions.
GENERAl
Problem
The power does not turn
on.
The system suddenly turns
off.
No sound is heard after a
function is selected.
Can't operate the remote
control.
The display is dark or off.
CONNECTED COmPONENTS
Problem
There is no sound from the
selected component.
Sound is interrupted or
there is noise.
No sound is heard or there
is noise when software with
DTS is played back.
During playback search,
there is noise from a DTS
compatible CD player.
• Disconnect the power plug from the outlet, and connect again.
• After about a minute (you won't be able to turn the unit on during this
time), turn the system back on. If the message persists, call an authorized
independent service company.
• Make sure the component is connected correctly.
(See "CONNECTIONS" on page 12.)
Press mUTE to restore the sound.
•
• Replace the batteries. (See page 11.)
• Operate within 7 m, 30° of the remote sensor
Remove any obstacles, or operate from another position.
•
• Avoid exposing the remote sensor on the front panel to direct light.
• Press DImmER on the control repeatedly to return to the default setting.
• Check that the component is connected correctly to the audio input jacks of
components.
Check that the cords are fully inserted into the jacks on both the component
•
and the main unit.
• Ensure that the component is selected correctly.
• Check the output audio formats support system.
• Set the digital volume level of the system to full, or to the neutral position.
Ensure the player's settings are correct and/or the DTS signal out is on.
•
Refer to the instruction manual supplied with the DVD player.
• This is not a malfunction, but be sure to turn the volume down to prevent
the output of loud noise from the system.
Remedy
Remedy
25