Troubleshooting - Dometic GROUP BordBar TB08 Instrucciones De Uso

BordBar TB08
9

Troubleshooting

Problem
Your cooler is not work-
ing and the fan wheel
which can be seen from
the outside is not turn-
ing.
The ignition is on and
the cooler is not work-
ing.
Pull the plug out of the
socket immediately and
make the following
inspections.
Your cooler does not
cool satisfactorily and
the outer fan wheel is
not turning.
The cooler does not
cool satisfactorily and
the outer fan wheel is
turning.
EN
Possible cause
No voltage is flowing
from the cigarette
lighter in your vehicle.
The cigarette lighter
socket is dirty. This
results in a poor elec-
trical contact.
The fuse of the con-
nection cable has
blown.
The vehicle fuse has
blown.
The fan motor is
defective.
The fan motor for the
inner fan is defective.
The Peltier element is
defective.
The integrated mains
adapter is defective.
Suggested remedy
The ignition must be switched on in most
vehicles to supply current to the cigarette
lighter.
Clean the socket of the cigarette lighter
with a non-metallic brush and a solvent, to
ensure that the middle contact pin is clean.
If the plug of your cooler becomes very
warm in the cigarette lighter socket, either
the socket must be cleaned or the plug
has not been assembled correctly.
Replace the connection cable fuse (5 A).
Replace the vehicle cigarette lighter fuse
(usually 15 A). Please refer to the operat-
ing manual of your vehicle.
This can only be repaired by an authorised
repair centre.
This can only be repaired by an authorised
repair centre.
This can only be repaired by an authorised
repair centre.
Troubleshooting
21