Max HN120 Manual De Operaciones página 15

APPLICATIONS AND PINS/NAILS SELECTION CRITERIA
The Machine is applicable to the following purposes. When using it, select the pins/nails and leg length suitable for the driving
object.
Application
Securing a thin steel Plastic
plate to the concrete Coil Pins
Ex.: Securing partition
tracks
Securing a wooden Plastic
material to the concrete Coil Nails
Ex.: Securing drum
edges
Securing a wooden Plastic
material to a thick steel Coil Nails
plate (For Steel
Plate)
CAUTION:
When using, allow for
the nature of the driving
object and the
conditions at the work
site to comply with the
Work Standards.
Type
Thin Steel Plate
Penetration Amount into
Concrete
Select the pins so that a penetration
amount into the concrete will be 7/8･ to
1･ (20 to 25mm).
Wooden Material
Sinks 1/16･ to 3/16･ (2 to 5
mm)
Concrete
Reference
Wooden Material
Nail Length Selected
Thickness
1-1/8･ (27mm)
1-3/16･ (30mm)
1-3/4･ (45mm)
Wooden Material
Sinks 1/16･ to 3/16
･ (2 to 5 mm)
Penetration
Amount
Thick Steel Plate
Select the nails so that a
penetration amount into the
thick steel plate will be 3/8･ (10
mm) or more.
Size (Leg Length)
CAUTION:
Use of nails to secure
the thin steel plate to the
concrete causes them to
recoil or bend,
endangering you. Be
sure to use pins to
secure it to the
Select the nails so
that a penetration
amount into the
concrete will be
Penetration Amount
5/8･ to 1･ (15 to
into Concrete
25mm).
Penetration Amount into
Concrete
1-1/2･ (38mm) Approx. 1/2･ to 5/8･ (13 to 16 mm)
1-3/4･ (45mm) Approx. 5/8･ to 7/8･ (17 to 20 mm)
2-3/8･ (60mm) Approx. 5/8･ to 7/8･ (17 to 20 mm)
CAUTION:
● Drivable steel plate thickness
is 1/8サ to 11/64サ (3.2 to 4.5
mm). Use the Machine only
within these limits.
● Overdriving into the steel
plate reduces a holding force
extremely and deteriorates
durability of the Machine.
When working, check the
driving condition fully to
adjust the pressure.
● Never drive the nails directly
into the thick steel plate,
because they may recoil or
bend, endangering you.
● Be sure to apply the nose of
the ejection port to the object
at a right angle.
● Do not use the Machine for
15
Attachment Used
Attachment-A,
Attachment-C
Attachment-B
CAUTION:
Use of the attachment-A
causes a nail sticking
out to the wooden
material.
Attachment-B
CAUTION:
Use of the attachment-A
causes a nail sticking
out to the wooden
material.