Level Meter; Memory; Store - Phonic PAA3 Manual Del Usuario

Level Meter

Measure the line voltage level in units of dBu, dBV, and
AC voltage, using standard response time, and standard
A, C, or flat weightings (under normal conditions, flat is
preferable). Using the PAA3 to meaure DC voltage may
damage the PAA3 and will void the warranty.
Procedure:
Enter the SPL / LINE menu and set the measurement
1.
unit to dBu, dBV, or voltage, as required.
You may select a range level, weighting, response
2.
time or a maximum level by going into the SETTINGS
menu, then onto the appropriate menus. The selected
values of these options will be displayed above the
RTA on the PAA3's default screen.
On the main RTA display, hold the ENTER button for
3.
approximately 2 seconds to activate the Level Meter
screen. Press the ENTER button once to exit.
NB. You can easily refresh the Max SPL value by holding
both the ← left and → right keys simultaneously for at
least one second.
ATTENTION:
If the level is lower than 127 mV when measuring voltage,
the PAA3 will show it in mV. If the level is higher than
127mV, the data will be shown in voltage For example,
120mV will read as 120.0mV, and 200mV will be shown
as 0.2V.
The measurements for line voltage cannot be saved into
the memory of the PAA3.
PAA3

MEMORY

The sub-menus of MEMORY include: STORE, RECALL,
AVERAGE, EQ SETTING. Through these options, users
are able to store their RTA measurements.

Store

The user can save up to 10 sets of measured data (1 to 10),
as well as 6 averaged sets (A to F), into the memory of the
PAA3, allowing them to be used later for further analysis
or uploading to your computer.
MEMORY
STORE
YES
NO
3 7
4 8
A 31
100 315 1K
Procedure (after making an accoustic
RTA measurement):
To enter the store menu, hold the right button down
1.
and press ENTER, or go into the MEMORY menu
and select STORE.
Select any slot, from position 1 to 10, and press YES
2.
to finalize. Previously saved data will be over-written.
Memory locations with stored data will be indicated
3.
with a box surrounding the slot number.
Selecting A/C in the STORE menu will automatically
4.
clear all memory slots.
ATTENTION: This function is only available when for
accoustic analysis.
9
10
ESC
3.15K
10K
9