Earlex WS125 Manual De Instrucciones página 8

EN B40
WARNING (UK ONLY)
Your unit has been supplied with a supply cord and a
fitted plug. This is identified by the fuse holder in the base
of the plug. Please read the following safety instructions
before use.
1. If the fitted plug is cut off from the supply cord then
the plug must be disposed of safely. NEVER under any circumstances insert
such a plug into a 13 Amp socket-outlet.
2. NEVER under any circumstances use the appliance or supply cord without the fuse cover
fitted. This is the little cover fixed into the base of plug to hold the fuse in place.
3. If you lose the fuse cover then please contact any electrical dealer for a replacement or ring
our helpline above.
4. A replacement fuse must be rated at 13 Amps and approved to BS1362.
5. IF IN ANY DOUBT PLEASE CONSULT A QUALIFIED ELECTRICIAN.
If you need to fit a plug to the supply cord, this should be fitted in accordance with the wiring
instructions below, and will need to be used with a 13 Amp fuse. If in doubt consult a qualified
electrician.
WARNING - THlS APPLIANCE MUST BE EARTHED. If you are using an extension lead it must
be rated a minimum of 10 Amps and fully unwound. Do not operate with a cord rated less
than 10 Amps as this will cause premature failure of the element which is not covered by the
guarantee. As the colours of the wires in the supply cord of this appliance may not correspond
with the coloured markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured green and yellow must be connected to the terminal in the plug
which is marked with the letter E or by the earth symbol, or coloured green.
The wire which is coloured blue must be connected to the terminal which is marked with the
letter N or coloured black.
The wire which is coloured brown must be connected to the terminal which is marked with
the letter L or coloured red.
8