Replacing The Lamp; Resetting The Lamp Timer - Hitachi CP-S225W Manual De Usuario

M A I N T E N
M A I N T E N

Replacing the Lamp

1. Switch the projector OFF, remove the power cord from the
power outlet, and wait at least 45 minutes for the unit to cool.
2. Prepare a new lamp.
3. Check that the projector has cooled sufficiently, and gently
turn it upside down.
4. Loosen the two screws as shown in the diagram, and remove
the lamp cover.
5. Loosen the one screw, and gently remove the lamp while
holding the grips. Touching the inside of the lamp case may
result in uneven coloring.
6. Install the new lamp and tighten the one screw firmly. Also
steadily push the opposite side of the screwed lamp into the
unit.
7. Replace the lamp cover in position and tighten the two
screws firmly.
8. Gently turn the projector right-side up.
CAUTION • Ensure that screws are tightened
properly. Screws not tightened fully may result
in injury or accidents.
• Do not use the projector with the lamp cover
removed.

Resetting the Lamp Timer

Reset the lamp timer after replacing the lamp. When the message of "CHANGE THE LAMP ...
THE POWER WILL TURN OFF AFTER 0 hr." is displayed, complete the following operation
within 10 minutes. The power will be turned off automatically in over 10 minutes.
1. Switch power ON, and press the RESET button, for approximately three seconds. The 'LAMP
xxxx hr' message will appear on the lamp timer on the bottom of the screen.
2. Press the MENU button on the remote control transmitter, or the RESET button on the control
panel, while the lamp timer is displayed. The 'LAMP xxxx
then appear.
3. Press the and select 0, and wait until the timer display is cleared.
•
NOTE Do not reset the lamp timer without replacing the lamp. Reset the lamp timer always
when replacing the lamp. The message functions will not operate properly if the lamp timer is not
reset correctly.
A N C E ( c o
A N C E ( c o
n t i n u e d )
n t i n u e d )
0 ■ CANCEL' message will
→
ENGLISH-17