Assembly - RIDGID R8611504 Manual Del Operador

FEATURES
PRODUCT SPECIFICATIONS
No Load Speed ....................... 0-450/0-1,650 r/min. (RPM)
Blows (impacts) per minute ..............0-5,850/0-21,450 IPM

ASSEMBLY

UNPACKING
This product requires assembly.
 Carefully remove the tool and any accessories from the
box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assembled
to the product by the manufacturer and require
customer installation. Use of a product that may
have been improperly assembled could result in
serious personal injury.
 If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of
this product with damaged or missing parts could
result in serious personal injury.
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended
for use with this product. Any such alteration
or modification is misuse and could result in a
hazardous condition leading to possible serious
personal injury.
Clutch ................................................................ 24 Position
Torque ................................................................... 550 in.lb.
INSTALLING/REMOVING THE AUXILIARY
HANDLE ASSEMBLY
See Figures 1 - 2, page 10.
The auxiliary handle assembly has handle position options.
To install the auxiliary handle assembly:
 Remove the battery pack.
 Turn the handle grip counterclockwise to loosen it and
open the hooks wide enough to fit over the mounting ribs,
behind the torque adjustment ring.
 Place the hooks over the mounting ribs, making sure the
hooks are positioned in the slots as shown.
 Turn the handle grip clockwise to tighten. Make sure the
handle assembly is secure before beginning operation.
To remove the handle assembly and install it on the op-
posite side:
 Turn the handle grip counterclockwise to loosen and
remove the handle assembly.
 Reinstall the handle assembly in the desired position.
NOTE: The auxiliary handle assembly may also be in-
stalled in a vertical position as shown.
5 - English