Start-Up; Checking The Mower Mechanism; Oil Fill; Fuel Fill - AL-KO solo Comfort 220 l Traducción Del Manual Original De Instrucciones

GB

6 START-UP

WARNING!
Danger if assembly is not carried out
completely!
Do not operate the lawn tractor before it
has been fully assembled!
Carry out all the work described in the
assembly instructions. If you are uncer-
tain about anything, ask a specialist to
confirm that the assembly has been car-
ried out correctly before the machine is
started up!
Check whether all safety and protective
devices are in place and functioning cor-
rectly!
6.1

Checking the mower mechanism

Before use, always look and check whether the
cutter, fastening pin and the entire mowing unit
are worn or damaged. Worn or damaged blades
must be renewed by new ones in order to avoid
any imbalance.
6.2

Oil fill

The engine must be filled with oil before initial
start-up. Please comply with the instructions from
the engine manufacturer in this regard. Also
make sure the oil level is checked at regular in-
tervals and the oil is topped up if necessary.
6.3

Fuel fill

WARNING!
Dangers when handling fuel!
Fuel is highly inflammable. Only fill the
fuel tank outdoors! Do not smoke! Do
not refuel when the engine is running or
is hot!
Use a suitable funnel or a filler pipe when refuel-
ling so that no fuel is spilled on the engine, the
deck or the ground.
For safety reasons, the fuel tank cap and other
tank caps must be renewed if damaged.
Do not start the engine if the fuel has overflowed.
The tractor must be removed from the area con-
taminated by fuel, and the spilled fuel must be
absorbed and wiped away from the ground, the
engine and the deck using a cloth.
Do not make any attempt to start the machine un-
til fuel vapours have evaporated.
Only keep the fuel in containers intended for this
purpose.
36
Use lead-free petrol, min. RON 91.
Filling the tank
1. Switch off the engine if it is running and re-
move the ignition key as a precaution.
2. Wait until the engine has cooled down some-
what (risk of explosion if the fuel catches
fire!).
3. Open the engine cover.
4. Open the tank cap (06/1) and pour in the fuel.
Note: Avoid overfilling the fuel tank!
5. Close the tank cap (06/1).
6. Close the engine cover.
6.4

Checking the tyre pressure

■
Check the tyre pressure at regular intervals.
■
Please refer to the specification on the tyre
for the necessary inflation pressure (recom-
mendation: 1 bar).
NOTE
1 PSI = 0.07 bar.
The tyre pressure can be checked and the tyre
inflated using a commercially available foot
pump.
6.5

Mounting the grass catcher

Lawn tractors are supplied with a grass catcher.
Please note that the illustrations may differ some-
what from the original.
Adjusting the fill-level sensor of the grass
catcher
The fill-level sensor uses a horn to signal when
the grass catcher must be emptied.
The fill-level sensor can be set to 6 positions, de-
pending on the condition of the cut grass. With
dry grass, push the fill-level sensor to the smaller
positions. With wet or damp grass, set the fill-lev-
el sensor to the higher positions. This influences
the filling of the grass catcher.
1. Switch off the engine see chapter 7.4 "Start-
ing and stopping the engine", page 39.
2. Remove the grass catcher see chapter 8.1
"Cleaning the grass catcher", page 42.
3. Adjust the fill-level sensor (07/1) to suit the
grass to be cut (07/a) until it engages in the
desired position.
4. Hook in the grass catcher again see chapter
6.5 "Mounting the grass catcher", page 36.
Start-up