Important Safety Instructions; Warning; Cautions Concerning Operation; Installation Guidelines - Sharp IG-A40U Manual De Funcionamiento

IMPORTANT SAFETY INSTRUCTIONS

When using electrical appliances, basic safety precautions should be followed, including the following:
WARNING - To reduce the risk of electrical shock, fi re, or injury :
• Read all instructions before using the unit.
• Use only a 120 volt outlet.
• The Plasmacluster Ion Genrerator has a polarized plug (one blade is wider than the other). This plug will
fi t in a polarized outlet only one way. If the plug does not fi t into the outlet, reverse it. If it still does not fi t,
contact a qualifi ed electrician or service person.
• DO NOT use the unit if the power cord or plug is damaged, or the connection to the wall outlet is loosened.
• Periodically remove dust from the plug.
• DO NOT insert fi ngers or foreign objects into the air intake or air outlet.
• Always hold the plug and never pull on the cord when removing the power plug.
Electrical shock and/or fi re from a short circuit may result.
• DO NOT remove the plug when your hands are wet.
• DO NOT use the unit near gas appliances or fi replaces.
• If the power cord is damaged, it must be replaced by the manufacturer, its service agent, a Sharp Authorized
Service Center or similarly qualifi ed person in order to avoid a hazard.
• Be cautious when cleaning the unit.
Strong corrosive cleansers may damage the exterior.
Always unplug the unit before cleaning.
• DO NOT use it in the areas, where the unit may get wet.
• DO NOT use spray products near the unit.
• DO NOT use in the rooms, containing oil component, incense, cigarettes' sparks, and chemical fumes.
• DO NOT operate when using aerosol insecticides or in rooms where there is oily residue, incense, sparks
from lit cigarettes, chemical fumes in the air, or in locations where the unit may get wet, such as a bathroom.
• DO NOT use these silicone-containing products in the room where the unit is installed.
• Only a Sharp Authorized Service Center should service this Plasmacluster Ion Generator.
Contact the nearest Service Center for any problems, adjustments, or repairs.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or men-
tal capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• Do not ride the main unit and do not sit on or lean on it, it may cause the injury or damage to the unit.

CAUTIONS CONCERNING OPERATION:

• DO NOT block the air intake and/or air outlet.
• DO NOT use the unit near or on hot objects, such as stoves or heaters or where it may come into contact
with steam.
• Always operate the main unit in an upright position.
• Always unplug the unit before cleaning.
• Clean the exterior with a soft cloth only, otherwise the main unit surface may be damaged or cracked.
• Keep the main unit away from water.

INSTALLATION GUIDELINES:

• Place at least 6 1/2 ft (2m) away from equipment utilizing electric waves such as televisions or radios to avoid
electrical interference when using the unit.
• Avoid using in locations where the unit is exposed to condensation or drastic temperature changes. Appropri-
ate room temperature is between 32-95ºF (0-35ºC).
• Avoid locations where grease or oily smoke is generated, otherwise the main unit surface may crack as a re-
sult.
NOTE - Radio or TV Interference:
If this Plasmacluster Ion Generator may cause interference to radio or television reception,
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the unit and radio/TV receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This product fulfi ls the requirement of the International standard CISPR 11.
In conformity with this standard, this product is classifi ed as group 2 class B equipment.
Group 2 means that the equipment intentionally generates radio-frequency in the form of electromagnetic ra-
diation for electro-discharge machining equipment.
Class B equipment means that the equipment suitable to be used in domestic establishments.
E-6