Idexx SNAP Pro Analyzer Guia De Inicio Rapido página 7

Without an IDEXX VetLab Station
1. Tap New Patient on the SNAP Pro Home
screen to enter the patient's name and client ID.
When you have finished entering the information,
tap the Check Mark
2. Prepare the SNAP test,
but do not activate the
test.
3. Gently slide the SNAP test
into the port at the bottom
of the analyzer (well end
first) until it clicks into
position (see illustration on left).
When analysis is complete, results are shown on
the results screen and are saved on the analyzer
automatically.
Tip: The color of the status light indicates the
results of the run:
Green—all results are negative
Blue—at least one result is positive
Yellow—visual confirmation needed (use the
instructions on the right)
icon.
When you need to confirm results
If there are very light spots or unexpected color
development (such as debris or a blue tint) in the
results window, you may be prompted to confirm
some or all of a test's results. Results that need to be
confirmed are highlighted yellow.
1. If you believe the highlighted result is positive, tap
the plus icon.
OR
If you believe the highlighted result to be negative,
tap the minus icon.
2. When you have finished confirming the results, tap
the Check Mark icon. The results will then be
saved on the analyzer and sent to the IDEXX VetLab
Station (if applicable).
Note: To cancel the test and return to the Home
screen, tap the close icon .