Unold 48955 Instrucciones De Uso página 31

appliance stops making ice cubes
automatically at the set time.
14. Caution: If you interrupt the
process, the excess water runs
back into the water tank. The
ice cubes that are still attached
to the cooling linkage will drop
off into the ice container after a
while, and can then be taken out.
15. When the ice container is full this
s y m b o l
signal tone sounds.
16. The appliance automatically stops
making ice cubes.
17. Remove the ice container and
empty it. Insert the ice container
back into the appliance. Please
note that you must hold the ice
container slightly slanted when
inserting it in the appliance.
18. Then proceed the ice cube making
process.
19. In addition, the ice cube maker
automatically checks the water
level in the water tank. If the
water level is too low, this symbol
(9) lights up:
20. The appliance automatically stops
making ice cubes. Top up water as
described above; in this process
pay attention to the MAX mark
and do not overfill the appliance.
21. Close the ice container and press
the „ON" button.
22. When this symbol lights up
the water tank is blocked due to
overly-large ice cubes. Switch off
(8) lights up and a
the appliance and wait until the ice
cubes have melted slightly. Then
proceed with production of the
ice cubes (however, wait at least
3 minutes before proceeding, to
prevent appliance damage).
23. Please remember not to leave the
ice cubes in the ice container too
long, since they will melt. If you
do not wish to use the ice cubes
right away, you can store them in
the freezer.
24. After use, please leave the ice
cube maker open to prevent the
formation of mould or bacteria.
The water must be changed af-
ter 24 hours at the latest, for
reasons of hygiene.
31