General Information; Introduction; Foreword; Precautions - CEMO CMT10 Manual De Operación Y Mantenimiento

GB

1. General information

1.1 INTRODUCTION

This system has been designed for measuring
the transfer of Diesel, AdBlue® depending of pur-
chased model. It is not to be used to measure for
resale purposes.
i
ANY MODIFICATION TO THIS METER
WITHOUT "CEMO" WRITTEN
PERMISSION WILL VOID ANY
GUARANTEE AND FREE "CEMO"
FROM ANY RESPONSIBILITY.

1.2 FOREWORD

This manual has been made to give the user a
general knowledge about the equipment and the
necessary maintenance and operation instruc-
tions. Carefully read and understand this manual
before starting installation, maintenance or repair.
Maintenance schedules proposed in this manual
are meant to be the minimal required for efficiency,
safety and endurance of the equipment in normal
operating conditions. Be observant for any type of
malfunction or potential safety issue at all times.
Disconnect electrical power before removing pro-
tective covers as prescribed by the Standard 292/2
Nov. 1992. for maintenance, repair and general
lubrication by authorized personnel.

1.3 PRECAUTIONS

Improper use or installation of this product can
cause serious bodily injury or death! To ensure
safe and efficient operation, it is necessary to read
and follow each of these warnings and precautions:
• Do NOT smoke near meter or use meter near an
open flame;
• This product should NOT be used for fluid
transfer into aircraft;
• Any type of service, maintenance, control must
be done by qualified personal.
• During maintenance operations and services,
make sure to have disconnected the power supply.
• Do not exceed the maximum pressure of 3,5 bar
4

1.4 GENERAL SAFETY NORMS

always wear a protection equipment that is suit-
able to the operations to carry out according to the
liquid that is being used. if any doubt review the
product safety sheet. During installation, use and
maintenance always wear the correct protection
equipment: gloves, glass, shoes and clothings.

1.5 DISCARDING AND RECYCLING

The metallic parts of system must be separated
and sent to appropriate metal recycling mills. the
fuels in the tanks of the installation will be collected
and sent to an authorized disposer. All plastic and
non-degradable material parts will be separately
collected and sent to an authorized disposer or
recycler. in conformity with the European Directive
2002/96/ EC concerning the elimination of electric
and electronic equipments, (WEEE), the symbol
herewith on the pump and/or on its packaging indi-
cates that you have to dispose of packaging for the
product in a responsible manner. It is suitable for
recycling.
Help to protect the environment, take the packag-
ing to the local recycling service and place into the
appropriate recycling bin.
Never dispose of electrical equipment or batteries
in with your domestic waste. If your supplier offers
a disposal facility please use it or alternatively use
your local recycling service and dispose in the
correct manner. This will allow the recycling of raw
materials and help protect the environment.!.
1.6 HARMFUL EMISSIONS
none

1.7 FIRE PREVENTION

In case of fire, never use water, but use extinguish-
ing powders charged with CO2 only. Extinguishers
should be kept near to the meter. Combustion
of paints and plastic parts may produce toxic
emissions: use the normal precautions in case
of fire (always refer to the security supervisor of
the place of installation).