Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
GB
3.4.2 MASTER FUNCTIONS
Starting from "partial" screen, proceed with
to enter in MASTER mode. Approaching the
MASTER card, the systems sounds Beep (3 times)
and the screen "Prog" appears. In this mode,
button allows to go to next function while
-button confirms the selection. The succession of
screens pressing each time the button
is as follows
1. CANCEL TOTALS,
with preceding message "CLRTOT"
2. TRANSACTION PRESELECTION,
with preceding message "PRESET"
3. PERIOD PRESELECTION,
with preceding message "PREPER"
4. PROGRAM TAG,
with preceding message "TAGSET"
5. AUTHORIZE/BLOCK TAG,
with preceding message "LOCHED"
6. UNIT OF MEASURE,
with preceding message "UNIT"
7. CALIBRATION,
with preceding message "CAL"
8. Set Date and Time
9. SETTING PARAMETERS,
with preceding message "SETPAR"
10. EXIT,
with preceding message "EXIT"
condition is used to describe
the different MASTER mode screens.
In this mode, should nothing happen
during 60 seconds, system automati-
cally returns to USER mode on "par-
tial" screen.
10
3.4.1.1 SCREEN "CANCEL TOTALS"
MESSAGE "CLRTOT"
CLrtot
This function permits to cancel totals for
each user, resetting TAG to initial conditions for
refuelling, except those that are blocked.
With this function, the GENERAL TOTAL will not
be reset, only the PERIOD TOTAL and users totals
will be reset to zero.
To cancel period totals do as follows:
1. enter in master mode
2.
to confirm
3.
to select YES or NO
4.
to confirm; the display shows "ok" to
confirm cancellation. To exit, wait 60 secondi or
press several times
confirm with
.
3.4.1.2 SCREEN "PRESELECTION ON
TRANSACTION", MESSAGE "PRESET"
PrESEt
This function permits to set a maxi-
mum of units for each transaction for the user
TAG key to program. Press
function. Press
until the desired maximum
quantity is on the display.
value while
decrements it. Wait 10 seconds
to confirm/save the value.
to display "EXIT" then
to enter in this
increments the
Publicidad
Capítulos
Tabla de contenido
