Using The Converter - Schumacher Electric BE01255 Manual Del Usuario

5.8 USING THE CONVERTER

It is important to know the continuous wattage of the device you plan to use with the converter. The portable
power must be used with devices drawing 200 watts or less. If the wattage is not marked on the device, use
only devices that draw less than 1.7 amps of AC current.
Devices like TVs, fans or electric motors require additional power to start (commonly known as the
"starting or peak power"). The portable power can supply a momentary surge in wattage; however even
devices rated less than the maximum 200 watts can exceed the converter's surge capability and cause
an automatic overload shutdown.
Do not use the converter with a product that draws a higher wattage than the converter can provide, as
this may cause damage to the converter and the product.
Make sure the device you are using is compatible with a modified sine wave converter.
CAUTION: Always run a test to establish whether the converter will operate a particular piece of
equipment or device.
In the event of a power overload, the converter is designed to automatically shut down. This safety feature
prevents damaging the converter while testing devices and equipment with the 200-watt range.
IMPORTANT: If you are using the power converter to operate any type of battery charger, monitor
the temperature of the battery charger for about 10 minutes. If the battery charger becomes
abnormally warm, disconnect it from the converter immediately.
You can use an extension cord from the converter to the device without significantly decreasing the
power being generated by the converter. For best operating results, the extension cord should be 16
AWG (1.31 mm
2
IMPORTANT: This converter uses a modified sine waveform, which is not quite the same as power
company electricity. For the following devices, we strongly recommend that you use caution and check the
device's manual to make sure it is compatible with modified sine waveform.
1. Switch mode power supplies
2. Linear power supplies
3. Class 2 transformers
4. Line filter capacitors
5. Shaded pole motors
6. Fan motors
7. Fluorescent and high-intensity lamps (with a ballast)
8. Transformerless battery chargers
Using the converter with any of these devices may cause the device to run warmer or overheat.
5.9 POWERING A 110V AC DEVICE
1. Ensure the battery clips are securely on the storage holders.
2. Open the protective cover of the AC power outlet on the front panel of the portable power.
3. Make sure the 110V AC device to be operated is turned OFF.
4. Plug the 110V AC device into the AC power outlet and press the
5. Turn the device on.
6. Charge the portable power as soon as possible after each use.
WARNING: RISK OF ELECTRIC SHOCK.
Incorrect operation of your converter may result in damage and personal injury. The converter output is
110V AC and can shock or electrocute the same as any ordinary household AC wall outlet.
NOTE: The maximum continuous load is 200 watts. Do not use the converter with a product that draws
more than 200 watts, as this may cause damage to the converter and the product.
) or larger and no longer than 50 feet.
• 10 •
Converter button.