Starting Operation - Bosch PSS 300 AE Instrucciones De Servicio

OBJ_BUCH-2 609 001 140-001.book Page 4 Tuesday, May 24, 2005 9:08 AM
Selecting the Sanding Sheet
Depending on the material to be worked and the
required rate of material removal, different sanding
sheets are available:
For the working of all
wooden materials
For coarse-sanding, e. g. of
rough, unplaned beams and
boards
For face sanding and planing
small irregularities
For finish and fine sanding of
hard woods
For the working of
paint/enamel coats or
primers and fillers
For sanding off paint
For sanding primer
For final sanding of primers
before coating
Replacing the Sanding Plate
Before any work on the machine itself, pull the
mains plug.
The sanding plate 5 can be replaced, if required.
Unscrew the 6 screws 11 completely and remove the
sanding plate 5. Attach the new sanding plate 5 and
tighten the screws again.
2 609 001 140 • 24.5.05
Operation

Starting Operation

Observe correct mains voltage! The voltage of the
Grain size
power source must agree with the voltage specified on
40—240
the nameplate of the machine. Power tools marked with
230 V can also be operated with 220 V.
Switching On and Off
coarse 40, 60
To start the machine, push the On/Off switch 2
towards the front to "I".
To switch off the machine, push the On/Off switch 2
towards the rear to "0".
medium 80, 100,
120
Preselecting the Orbital Stroke Rate
fine 180, 240
With the thumbwheel for preselection of the orbital
stroke rate 1, you can preselect the required orbital
40—320
stroke rate, even during operation.
The required stroke rate depends on the material and
the working conditions and can be determined through
practical testing.
coarse 40, 60
Operating Instructions
medium 80, 100,
B Wait until the machine has come to a stand-
120
still before placing it down.
fine 180, 240,
The removal capacity during sanding is mainly deter-
320
mined by the selection of the sanding sheet as well as
the preselected orbital stroke rate.
Only flawless sanding sheets achieve good sanding
capacity and extend the service life of the machine.
Pay attention to apply uniform sanding pressure; this
increases the working life of the sanding sheets.
Intensifiying the sanding pressure does not lead to an
increase of the sanding capacity, but to increased wear
of the machine and the sanding sheet.
A sanding sheet that has been used for metal should
not be used for other materials.
Use only original Bosch sanding accessories.
English–4