6Shfl¿F Vdihw\ Dgylfh; Installation; Installation Recommendations; Fitting The Heating Slim Receiver Rts 2Kw With Standard Connections - SOMFY RTS 2kW Manual Del Instalador

Heating Slim Receiver RTS 2kW / Heating Slim Receiver RTS 2kW Plug
2.2.6SHFL¿F VDIHW\ DGYLFH
The Heating Slim Receiver RTS 2kW must be installed in a location sheltered from bad weather,
and out of the reach of children.
1) 0DNH D ORRS RQ WKH FDEOHV IRU WKH +HDWLQJ 6OLP
Receiver RTS 2kW with standard connections to
prevent water ingress.
2) Ensure that the total power of the heating lamp(s)
connected to the Heating Slim Receiver RTS 2kW
3&% GRHV QRW H[FHHG  :
 Never connect several Heating Slim Receiver RTS
2kW units to a single heating lamp or heating ramp.
 The type of metal surface located near to the
Heating Slim Receiver RTS 2kW may reduce the
radio range.
5) &KHFN WKH UDGLR UDQJH EHIRUH ¿WWLQJ WKH +HDWLQJ
Slim Receiver RTS 2kW. The radio range may be
limited by radio appliance control standards.
The use of a radio appliance (e.g. Hi-Fi radio
headphones) operating on the same frequency
may cause interference and be detrimental to the
product's performance.
6) The building in which the product is used may
reduce the radio range. The radio range is
;  P LQ RSHQ VSDFH “  
 Ensure that the electrical network is protected by a
16 A circuit breaker.

3. Installation

3.1. Installation recommendations

‡ 0LQLPXP GLVWDQFH EHWZHHQ D +HDWLQJ 6OLP 5HFHLYHU 576 N: DQG WKH JURXQG HJ  FP
between any RTS control points and/or between any control point and any motor).
‡ Installation of the Heating Slim Receiver RTS 2kW depends on the ramp it is used with, refer to the
WHFKQLFDO VSHFL¿FDWLRQV VXSSOLHG E\ 6RPI\ 7HFKQLFDO GDWD VHFWLRQ 
‡ Do not install the Heating Slim Receiver RTS 2kW under the heating ramp.

3.2 Fitting the Heating Slim Receiver RTS 2kW with standard connections

Install the Heating Slim Receiver RTS 2kW in a sealed connection unit (not supplied) to make
the internal connections or use sealed connectors (not supplied) to ensure the unit is properly
sealed.
- Cut off the mains power supply
- Connect the Heating Slim Receiver RTS 2kW in
accordance with the wiring:
- Heat = Heating ramp side (a)
-  9 VXSSO\ 3RZHU VXSSO\ VLGH E
- 0RXQW WKH +HDWLQJ 6OLP 5HFHLYHU 576 N: IRU
example with Rilsan® clips).
a
Blue 2XWSXW
Brown 2XWSXW
Green/yellow Earth
26
b
Brown Live input (L)
Blue Neutral input (N)
Green/yellow Earth
a
&RS\ULJKW ‹  6RPI\ 6$6 $OO ULJKWV UHVHUYHG
b