Heating Slim Receiver RTS 2kW / Heating Slim Receiver RTS 2kW Plug
5.2. Creating multiple or group controls
5.2.1. Group control
Group control: an RTS control point controls several Heating Slim Receiver RTS 2kW units.
1) Cut the power supply to the Heating Slim Receiver
RTS 2kW units (h, i and j) to be controlled by a
single control point.
2) 6ZLWFK RQ WKH SRZHU VXSSO\ WR WKH ¿UVW +HDWLQJ 6OLP
Receiver RTS 2kW (h) to be linked to the control
point.
Simultaneously press the Up/Down buttons on the
RTS control point: the heating lamp comes on then
goes out.
3UHVV WKH 352* EXWWRQ RQ WKH 576 FRQWURO SRLQW
the heating lamp will come on then go out again
to indicate that the RTS control point has been
programmed into the Heating Slim Receiver RTS
2kW.
5) Switch off the power supply to the newly linked
Heating Slim Receiver RTS 2kW before adding the
next Heating Slim Receiver RTS 2kW.
6) Switch on the power supply to another Heating
6OLP 5HFHLYHU 576 N: WR EH OLQNHG DQG UHSHDW VWHSV DQG
- Repeat the procedure for each of the other Heating Slim Receiver RTS 2kW units to be controlled
with this RTS control point.
5.2.2. Multiple control
0XOWLSOH FRQWURO D +HDWLQJ 6OLP 5HFHLYHU 576 N: LV FRQWUROOHG E\ VHYHUDO 576 FRQWURO SRLQWV
A maximum of 12 control points may be programmed
into a Heating Slim Receiver RTS 2kW.
1) 3UHVV WKH 352* EXWWRQ RQ WKH SURJUDPPHG FRQWURO
point (k) until the heating lamp comes on then goes
out: the Heating Slim Receiver RTS 2kW will be in
programming mode for 2 minutes.
2) %ULHÀ\ SUHVV WKH 352* EXWWRQ RQ WKH 576 FRQWURO
point (l) to be added: the heating lamp comes on
WKHQ JRHV RXW WKH 576 FRQWURO SRLQW KDV EHHQ
added/removed.
- Repeat these two steps to add each RTS control
point.
6. Using the heating ramp
With an RTS control point
To switch on the heating ramp:
- Press the Up button.
To switch off the heating ramp:
- Press the Down button.
7. Tips and recommendations
7.1. Questions on the Heating Slim Receiver RTS 2kW?
Observations
Pressing a button on the
control point has no effect
on the heating ramp
28
Possible causes
2QH RU PRUH KHDWLQJ ODPSV LV EORZQ
1
OFF
h
2
ON
h
4
PROG.
h
1
PROG.
k
Solutions
Replace the heating lamp(s).
&RS\ULJKW 6RPI\ 6$6 $OO ULJKWV UHVHUYHG
i
j
3
h
h
2
PROG.
l
2 min.