Setup Within The Vehicle - Brevi CX isofix tt Manual De Instrucciones

with the vehicle it is to be used in.
CONTENTS
1. Warning
2. Product composition
3. Installation positions within the vehicle

4. Setup within the vehicle

5. Installation in the vehicle/ Group 0+
5.1.Installing the child seat
5.2.Fastening the child into the seat
6.Installation in the vehicle/ Group 1
6.1.Installing the child seat with ISOFIX and Top tether
6.2.Installing the child seat with three point belt
6.3.Fastening the child into the seat
7.Adjusting the seat
8.Child seat care and maintenance
9.Warranty
1.WARNINGS
Please read carefully before installing the child seat in the vehicle.
1.This child safety seat is suitable for use as group 0+/1 from ap-
prox.0 to 4 years age/ 0-18kg.
2.Please read this instructions carefully, as incorrect installation
could result in serious injury. If any injuries should occur as a
result of incorrect installation, the manufacturer will accept no
responsibility.
3.This child seat is in accordance with the ECE R44/04 regula-
tions and may be installed in the majority of vehicles equipped
with approved points, such as ISOFIX points, in accordance with
ECE regulation 16.
However, prior to purchase, the child seat should always be tested
in your vehicle with the child seated, in order to ensure that the
model meets your needs.
4.Never use the child safety seat without its cover.
5.Protect the child safety seat from direct sunlight, as the seat can
get very hot and harm the child.
6.Child seats or accessories that are damaged or have been used
incorrectly must be replaced.
7.Do not leave heavy objects inside the car, as these may injure
the child in the event of an accident.
8.Ensure that no part of the child seat is caught in the door of the
vehicle or in a reclining seat.
In addition, ensure that the safety seat is correctly installed and secured.
9.Do not disassemble, modify, or add any piece to the child seat
or harness, as this would seriously affect its basic functioning and
the safety that the child seat provides.
10.The safety seat must remain installed in the vehicle, even if the
child is not seated in the car seat.
The child must never be left unattended while seated in the safety
seat, not even outside the vehicle.
11.Keep the safety seat away from corrosive products.
12.The manufacturer guarantees the quality of its products, but
not the quality of second-hand products or products belonging to
other companies.
13.Instruction illustrations are for informational purposes only.
The child restraint system may contain small differences compa-
524-01-161124-00 ISTRUZIONI SEGG.AUTO CX GRUPPO 0+1.indd 15
red to the photographs or images in the instruction manual.
3.INSTALLATION POSITIONS WITHIN THE VEHICLE
4.SETUP WITHIN THE VEHICLE
Facing the direction of travel (group 1)
Facing away from the direction of travel (group 0+)
With the 2-point belt (car seatbelt)
With the front airbag
On seats with:
Group 1:
(1) ISOFIX anchorage points (between the seat and the seat
back) and top tether anchorage points (such as on the rear shelf,
on the ground or behind the seat, ecc.)
(2) 3-point seatbelts
Group 0+: 3-point seatbelts
4.SETUP WITHIN THE VEHICLE
Place the child seat in the rear of the vehicle, facing away from the
direction of travel (group 0) or facing forward (group1).
The child seat must be as closely attached to the vehicle's seat
as possible.
For vehicles with adjustable headrests, a better installation can be
achieved by adjusting the height or removing the headrest (Group1).
It is important to replace the headrest in its position when an adult
is travelling.
The child seat must not be transported in the vehicle without being
buckled in, even when the child is not travelling in the child seat. It
is very important to keep this in mind, in order to avoid any dama-
ge that the child seat could cause in the event of an accident. The
child seat must therefore remain installed at all times while driving.
Group 0+
Group 0+ 1
15
24/11/2016 16.34.04