Erreka KM 600S Manual De Instrucciones página 16

Accionadores para portas de correr
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

INTRODUCTION
These products have been designed for the automation of sliding garage doors.
The instructions have been validated in order to facilitate the installation of the models indicated in the table below.
TECHNICAL CHARACTERISTCIS
- Single-phase motor with permanent condenser
- Power supply:
- Outgoing speed:
- Protection factor:
- Gentle stop at the end of its run.
Model
Security
KM 600S
Encoder + Electronic regulator
KM 1000S
Encoder + Electronic regulator
RECOMENDATIONS TO THE FITTER
It is important as far as safety as concerned to follow all the instructions. An incorrect instruction may cause damage to people and/or
property. Read the recommendations in this leaflet carefully; they give important information on the security of the installation and its
use and maintenance.
Once the product has been unpacked, check that it is undamaged. If you are in any doubt do not use the appliance and contact the
nearest technical service.
The elements of the packaging must be kept out of the reach of children, as these items are potentially dangerous.
It should also be checked that the door is in good mechanical condition.
Check that the mechanical operation of the door to be automated is correct.
If friction is excessive, this should be corrected before proceeding to automation.
Under no circumstances should an automation mechanism be installed in a door that is not operating correctly, as both the door and
the components installed may be damaged and this may even be dangerous.
This mechanism must only be put to the use for which it has been designed. Any other type of use must be considered unsuitable and
therefore dangerous.
The installation must be carried out by qualified personnel, respecting the manufacturer's instructions, and in accordance with current
regulations.
Pay particular attention to the instructions of all the elements that make up the installation.
Check that the normal voltage of the elements to be installed corresponds to that of the mains and that the power of the latter is
appropriate for the maximum power of the equipment.
Check that the section of the cables is suitable regarding the power absorbed by the elements. If in any doubt, consult a professional.
Never install any appliance without its corresponding earth connection.
The power cable must be appropriately secured.
Suitable cable housing must be used as a protection element.
For the installation it is necessary to provide a switch to insure the omnipolar cut-off of the power supply according to current security
regulations.
The use of any electrical appliance implies the observation of fundamental rules such as:
- Do not touch the appliance with wet hands or feet
- Do not handle the appliance with no shoes on.
- Do not leave the appliance exposed to the elements unless this is expressly anticipated
230 V-50Hz
57 r.p.m.
IP33
Blockage
Maximum weight
(kg)
Yes
600
Yes
1000
17
Power (W)
Intensity (A)
160
1.2
368
1.67
Table
Built-in
Built-in

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Km 1000s

Tabla de contenido