Charging The Internal Battery Of The Portable Power - Schumacher Electric DieHard 71686 Manual Del Propietário

4. CHARGING THE INTERNAL BATTERY OF THE
PORTABLE POWER
IMPORTANT!
CHARGE IMMEDIATELY AFTER
PURCHASE, AFTER EACH USE
AND EVERY 30 DAYS, TO KEEP
THE PORTABLE POWER'S
INTERNAL BATTERY FULLY
CHARGED AND PROLONG
BATTERY LIFE.
CHECKING THE LEVEL
OF THE INTERNAL BATTERY
Press the Battery Status button
on the front of the unit. The LED
lights will indicate the current
charge level as follows:
(green) solid – 100%-70% of
full charge.
(yellow/orange) solid – 70-
30% of full charge.
(yellow/orange) flashing –
Less than 30% of full charge.
CHARGING THE INTERNAL
BATTERY
Charge the internal battery for the
Portable Power using an extension
cord (not included).
NOTE: Use of an improper
extension cord could result in a risk
of fire and electric shock.
1. To charge, plug an 18 AWG or
larger extension cord into the
charger plug on the side of the
Portable Power.
2. Plug the extension cord into a
120VAC electrical wall outlet.
3. While the Portable Power
is charging, the
orange) LED will be lit until
the level reaches 70% of
charge, then the
LED will be solid until it is
fully charged. When fully
charged, the
will pulse. Complete charging
may take up to 72 hours.
4. When the internal battery is
fully charged, the charger will
automatically go into maintain
mode and maintain the battery
(yellow/
(green)
(green) LED
• 5 •
at full charge without damaging
it. When in maintain mode, the
(green) LED will pulse,
as long as there is an AC cord
connected to the charging port.
5. Charge the jump starter as
soon as possible after use.
CHARGING THE INTERNAL
BATTERY WHILE DRIVING
You may also charge the internal
battery while driving, using a
male-to-male charger cable
(part number 94500109 – sold
separately).
IMPORTANT:
DO NOT CHARGE INTERNAL
BATTERY FOR MORE THAN
30 MINUTES OR LEAVE THE
BATTERY UNATTENDED. IT
COULD EXPLODE, CAUSING
PROPERTY DAMAGE OR
PERSONAL INJURY.
1. Make sure the car is running.
2. Insert one end of the accessory
cable into the 12V DC power
outlet.
3. Insert the other end of the
accessory cable into the
vehicle's accessory outlet
(lighter socket).
NOTE: The green and yellow/
orange LEDs do not operate
during this method of charging.
Using this method to charge the
battery overrides the maintain
mode and the battery can be
overcharged.
4. Monitor the progress of the
charge by pressing the Battery
Status button on the front of
the unit. When the battery
is fully charged, disconnect
the accessory cable from the
Portable Power, then from the
lighter socket of the vehicle.
NOTE: Completely disconnect the
charger cable when the engine is
not running.