Digital Display - Schumacher DSR PRO Serie Manual Del Usuario

Arrancador portátil de 12 voltios con convertidor de energía
Ocultar thumbs Ver también para DSR PRO Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

If the negative post is grounded to the
chassis (as in most vehicles), see step
3.6. If the positive post is grounded to the
chassis, see step 3.7.
3.6 For a negative-grounded vehicle, connect
the POSITIVE (RED) clip from the jump
starter to the POSITIVE (POS, P, +)
ungrounded post of the battery. Connect
the NEGATIVE (BLACK) clip to the
vehicle chassis or engine block away from
the battery. Do not connect the clip to the
carburetor, fuel lines or sheet-metal body
parts. Connect to a heavy gauge metal
part of the frame or engine block.
4. FEATURES
1

4.1 Digital Display

When connected to a battery, the digital
display can be used to indicate the battery's
voltage. When not connected to a battery,
the digital display can be used to indicate
the percent of charge or the voltage of the
jump starter's internal battery.
To check the internal battery's charge
status, make sure the rotary switch is in
the OFF position, then press the display
3
2
4
5
6 7 8 9
3.7 For a positive-grounded vehicle, connect
the NEGATIVE (BLACK) clip from the
jump starter to the NEGATIVE (NEG, N, -)
ungrounded post of the battery. Connect
the POSITIVE (RED) clip to the vehicle
chassis or engine block away from the
battery. Do not connect the clip to the
carburetor, fuel lines or sheet-metal body
parts. Connect to a heavy gauge metal
part of the frame or engine block.
3.8 When disconnecting the jump starter, turn
all switches to off (if applicable), remove
the clip from the vehicle chassis, then
remove the clip from the battery terminal.
Jump Starter
1. 12 Volt DC power outlet
2. Jump starter ON/OFF switch
3. Multi-function digital display
4. Display button
5. Heavy-duty battery clamps
6. (2) AC outlets
7. Converter status LEDs
8. Converter/USB ON/OFF switch
9. USB port
Charger
1. Charging status LED
2. Bad Battery LED
3. Power LED
button on the front of the jump starter.
The digital display will show the battery's
percent of charge. A fully charged battery
will read 100%. Charge the internal battery
if the display shows it is under 100%.
NOTE: The internal battery's percent of
charge is most accurate when the jump
starter has been disconnected from all
devices and charging sources for a few
hours.
• 4 •
1
2
3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Dsr pro dsr116

Tabla de contenido