Transport And Storage; Safety References; Safety Measures - BEHA UNITEST TELARIS ISO plus Manual De Instrucciones

PTDB90690001.qxd:PTDB9069-02.qxd

2.0 Transport and Storage

Please keep the original packaging for later trans-
port, e.g. for calibration. Any transport damage due
to faulty packaging will be excluded from warranty
claims.
In order to avoid instrument damage, it is advised
to remove accumulators when not using the instru-
ment over a certain time period. However, should
the instrument be contaminated by leaking battery
cells, you are kindly requested to return it to the fac-
tory for cleaning and inspection.
Instruments must be stored in dry and closed areas.
In the case of an instrument being transported in ex-
treme temperatures, a recovery time of minimum 2
hours is required prior to instrument operation.

3.0 Safety Measures

The UNITEST TELARIS ISO plus has been desi-
gned and checked in accordance with the safety
regulations for Electronic test and Measurement
Instruments EN 61010 and IEC 61010, and left
our factory in a safe and perfect condition.
The respective accident prevention regulations
established by the professional associations for
electrical systems and equipment must be
strictly met at all times.
In order to avoid electrical shock, the valid safe-
ty and VDE regulations regarding excessive
contact voltages must receive utmost atten-
tion, when working with voltages exceeding
120V (60V) DC or 50V (25V)rms AC. The val-
ues in brackets are valid forlimited ranges (as
for example medicine and agriculture).
02.10.2008 15:36 Uhr
Transport and Storage / Safety Measures
Measurements in dangerous proximity of elec-
trical installations are only to be executed when
instructed by a responsible electrical specialist,
and never alone.
Prior to usage, inspect the instrument and used
test leads for external damage. Prior to any op-
eration, ensure that connecting leads used and
instruments are in perfect condition.
If the operator's safety is no longer ensured, the
instrument is to be put out of service and pro-
tected against use. The safety is no longer in-
sured, if the instrument:
- shows obvious damage
- does not carry out the desired measurements
- has been stored for too long under un-
favourable conditions
- has been subjected to mechanical stress dur-
ing transport.
The instrument may only be used within the op-
erating ranges as specified in the technical data
section.
Avoid any heating up of the instrument by di-
rect sunlight to ensure perfect functioning and
long instrument life.
Seite 25
25