Nailer Operation - Hitachi NV 50AP3 Instrucciones Y Manual De Seguridad

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

(4) 1 Close the washer magazine cover.
NOTE:
When closing the washer magazine cover, confirm
that the curl part of the washer spring is in the normal
position (cap connection position). If not in the normal
position, close the washer magazine cover once again.
If this is not done, the cap may not be sent properly.
Washer spring
2 Pull the knob in the direction of the arrow to pull
back the washer feeder and feed the lead cap to
the firing exit.
Knob
Curl part
Cap connection
position
Lead cap
Washer
feeder

NAILER OPERATION

Read section titled "SAFETY"(pages 4 – 7).
NEVER point tool at yourself or others in work
area.
Keep fingers AWAY from trigger when not driving
nails to avoid accidental firing.
Choice of triggering method is important.
Please read and understand "Methods of
Operation" below.
Before starting work, check the nailing operation
switching device.
This Hitachi nailer includes a nailing operation
switching device.
Before starting work, make sure that the
switching device is properly set.
If the switching device is not set properly, the
nailer will not operate correctly.
Never place your hands or feet closer than 8
inches (200 mm) from firing head when using.
Do not drive nails on top of other nails or with
Nailer at too steep of an angle; nails can ricochet
and hurt someone.
Do not drive nails into thin boards or near corners
and edges of workpiece. Nails can be driven
through or away from workpiece and hit
someone.
Never drive nails from both sides of a wall at the
same time. Nails can be driven into and through
the wall and hit a person on the opposite side.
Never use Nailer which is defective or operating
abnormally.
Do not use Nailer as hammer.
Disconnect air hose from Nailer when :
1) it is not in use;
2) leaving work area;
3) moving it to another location; and
4) handing it to another person.
— 15 —
DANGER
Operators and others in
work area MUST wear
safety glasses with side
shields which conforms
to ANSI Z87.1
specifications.
WARNING
English

Publicidad

Tabla de contenido
loading

Tabla de contenido