Clearing A Jam; Maintenance Maintenance And Inspection - Hitachi NV 50AP3 Instrucciones Y Manual De Seguridad

NOTE: The information contained in this Manual is designed to assist you in the safe maintenance of the Nailer.
Some illustrations in this Manual may show details or attachments that differ from those on your own Nailer.
MAINTENANCE AND INSPECTION
Read section titled "SAFETY" (pages 4 – 7).
WARNING
Disconnect air hose and remove all nails and caps
(washers) from Nailer when:
1) doing maintenance and inspection; and

2) clearing a jam.

Never use gasoline or other highly flammable
liquides for cleaning.
1. Clearing a jam
Remove a jammed nail in the following order :
1 DISCONNECT AIR HOSE.
2 Open the nail guide.
3 Insert a rod into the outlet.
Tap the rod with a hammer.
Hammer
Rod
Outlet
4 Remove the jammed nail with a slotted screw
driver.
Nail
5 Cut the deformed collated wire with nippers.
Correct the deformation.
6 In case of frequent jam, contact a Hitachi authorized
service center.
MAINTENANCE
1
Disconnect
air hose
Slotted screw driver
— 19 —
2. Inspecting the feeders
〈Nail feed unit〉
1 DISCONNECT AIR HOSE.
2 Clean the knob sliding part.
Lubricate it with Hitachi pneumatic tool lubricant.
Knob
Nail guide
3 Open the nail guide and remove dust.
Lubricate the sliding groove of the feeder and
shafts.
CAUTION
Check that nail stopper (A) and nail stopper (B) slide
smoothly by pushing them with finger.
If not smooth, nails can be driven at an irregular angle
and hurt someone.
Nail guide
Nail stopper (A)
Nail stopper (B)
4 Lubricate the feeding surfaces of the nose and the
nail guide after cleaning.
This promotes smooth operation and prevents rust.
English
1
Disconnect
air hose
Feeder
Shaft
Nose