mspa Mont Blanc Manual Del Usuario página 13

Spa Inflation
6.
6.1 Unscrew the air valve cap (a) on the control panel to reveal the air blower inflation outlet and connect
one end of the inflation hose (b) to the outlet. See Figure 6.1
6.2 Unscrew the air valve cap on the spa pool and reveal the stem for inflation.
6.3 Connect the other end of the inflation hose (b) to the manometer (c) first and then insert to the air
valve.
6.1
(b)
6.4 Press the Bubble
CAUTION: Do not over inflate. Over inflation may cause spa leakage and void the warranty.
6.5 Pay attention to the Manometer. The Yellow section appears when the spa is properly inflated. The
Green section shows when water filling is completed. Repeat previous steps if more air is necessary.
CAUTION: The Red section shows when the spa is over inflated. Press the black button (a) on the
manometer to release some air until it points the green section.
IMPORTANT: During spa use, the manometer shall only shows the Green section at all times.
6.4
6.6 When inflation is completed. Press Bubble
function. Disconnect the inflation hose on both ends. Replace the air valve cap back.
NOTE:
● The cap is designed to be screwed on and off. Never exert force as this could cause the complete
internal inflation system of the valve to come loose.
● If over inflated, remove the inflation hose from the spa air valve side, screw the valve cap to
release some air and stop until the manometer points to the right color section.
Spa Bladder Inflation.
7.
7.1 Open the air valve (a) on the bladder. Insert the inflation
hose (b) into the valve
7.2 Press the Bubble
to touch but not hard.
7.3 Press Bubble
turn off the function. Disconnect the inflation hose from the
air blower outlet and the valve
6.2
(a)
button to inflate the spa tub until it is firm to tough.
6.5
button to inflate until it is firm
button for more than 3 seconds to
13
6.3
11
(b)
Yellow
Green
Red
Over Inflation
button for more than 3 seconds to turn off the
7
(a)
(c)
Button
(a)
(c)
(b)