Troubleshooting - mspa Mont Blanc Manual Del Usuario

TROUBLESHOOTING

PROBLEM
NO DISPLAY ON
THE CONTROL
PANEL
NOT HEATING
PROPERLY
BUBBLE AIR
BLOWER DOES
NOT WORK
OZONATOR
FAILURE
CAUSE
Power failure
PRCD is off
PRCD broken
Press the Reset button, control
panel is not displayed
Digital cable
connection failure
Temperature set too low
Dirty filter cartridge
Water level is not at the minimum
water line
Heater failure
Filter pump broken
Digital cable connection failure
Auto-off 10 minutes
Unidirectional threshold is not open
Control panel failure
Digital cable connection failure
Water level is at the minimum
water line
One-way valve blocked
Filter pump does not work
Check power source
Reset PRCD
Contact the MSpa Service Center
Contact the MSpa Service Center
Connect the digital cable once again, ensure
the pins inside are well connected
Set a higher temperature
Clean or replace the filter cartridge
Add more water to the minimum line
Contact the MSpa Service Center
Contact the MSpa Service Center
Connect the digital cable once again, ensure
the pins inside are well connected
Wait for 10 minutes
Contact the MSpa Service Center
Contact the MSpa Service Center
Connect the digital cable once again, ensure
the pins inside are well connected
Add more water to the minimum line
Contact the MSpa Service Center
Refer to "FILTER PUMP DOES NOT WORK"
section
22
SOLUTION