Pump Lcd Menus And Operating Instructions - Enerpac Avdel 73440-02000 Manual De Instrucciones

Putting Into Service

Pump LCD Menus and Operating Instructions

•
Connect the unit to the power supply and switch on. Wait 5 seconds for the pump unit to complete the boot
sequence, before pressing the trigger switch. When all set, the LCD screen on the pump unit will display
'AVDEL' and a numeric display of the current pump-pressure. This should read '0 BAR'.
• During the boot sequence the pump control system identifies any trigger operation as a potential malfunction
and prevents the motor from starting. The LCD screen will display 'BUTTON FAULT' in this instance. Reset by
switching off the power supply for 10 seconds.
•
In addition to the tool trigger switch, which is used to operate the basic function of the pump, the pump control
unit also has four buttons below the LCD screen that are the main interface between the operator and the unit.
•
The On/Off MOTOR button toggles the motor Off. The Off function is available on this button even if the pump is
not in the LOCAL mode, but is operated by the placing tool.
•
The MENU button enables the operator to step from normal operational mode into menus. With repeated
pressing the operator steps through the various menus. Pressing the Menu button also saves any changes
made. To return to the normal operational mode, press and hold the Menu button for two seconds or don't push
any button for 60 seconds.
•
The Down Arrow and Up Arrow buttons serve two purposes. When the display shows one of the menus, the
Down Arrow and Up Arrow buttons are used to step through the menu's options. When the pump is placed in
LOCAL Mode, the Down Arrow and Up Arrow buttons switch the valve solenoid between the pull and return
side of the placing tool. The placing tool trigger is non-operational in LOCAL mode.
On/Off Menu
SCREEN 1
AVDEL
0
BAR
Down Up
Arrow Arrow
13