AEG DBS 5533 Instrucciones De Servicio página 31

CAUTION: INITIAL USE:
Please proceed as follows:
• The tank should only be fi lled up to the maximum
mark. Do not overfi ll!
• Close the water tank.
• Connect the base station to a 230 V / 50 Hz socket
with earthing contact.
• Turn the switch (4) on the base on.
• Set the desired temperature within the range „• •"
to „• • •".
• Please wait until the control lamp (6) on the base
lights up.
• Now press the steam jet button (11) for at least 1
minute or use the bar (12) to lock the steam jet
button in place.
NOTE:
• This time is needed for the steam to reach the
iron.
• Keep a cloth ready! During this phase water
also comes out of the soleplate of the iron.
• When only steam comes out without any water
you can stop the procedure. Then press the steam
jet button another 2-3 times without touching the
clothes that are to be ironed.
• After you have ironed an old but clean cloth a few
times, your station is ready for use.
NOTE: on Steam Ironing:
• While the pump is active do not press the steam jet
button (11).
• If you have been using the permanent steam func-
tion, release the bar (12).
• Wait until the control lamp (6) goes on again,
otherwise water can leak out of the soleplate of the
iron.
Vertical Steam
This can be used to produce a jet of steam in a vertical
direction.
Hang your laundry on a clothes hanger and move the
iron to approximately 2-3 cm away.
How can I replenish the water during operation?
Refi ll with water before the tank is completely empty.
The lamp (5) shows that there is not enough water.
• If you have been using the permanent steam func-
tion, release the bar (12).
• Set the temperature control to „0".
• Turn the switch (4) on the base off .
• Remove the mains plug from the socket.
• Remove the iron and the iron rest (7) and put both to
one side.
05-DBS 5533.indd 31 05-DBS 5533.indd 31
NOTE:
You should only touch the rest by the side handles (10)
or use an oven cloth. The surface warms up according
to how long you iron.
• In order to fi ll the water tank, push the lock (9) open
and use the funnel supplied.
• Fill the tank up to the maximum mark. Do not over-
fi ll!
• Close the water tank.
• Continue ironing.
NOTE:
Keep a cloth ready! At fi rst water may also be expelled
from the soleplate of the iron.
When you have fi nished
• Now you can start ironing. Always turn the tempe-
rature control to „0" after use and remove the mains
plug (the control lamp in the handle goes off ).
• Turn the switch (4) on the base off .
• Remove the mains plug from the socket.
• Empty the water tank.
• Allow the device to cool down before you put it
away.
Cleaning
AVVISO:
• Always remove the mains lead before cleaning!
• Wait until the machine has cooled down complete-
ly.
• Under no circumstances should you immerse the
device in water for cleaning purposes. Otherwise
this might result in an electric shock or fi re.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• Clean the casing with a slightly damp cloth.
• Clean the sole plate and the rest with a slightly damp
cloth.
• Any residual water can remain in the water tank, but
should be poured out if it has been in the tank for a
prolonged period.
English
31
09.02.2009 11:36:58 Uhr 09.02.2009 11:36:58 Uhr