Numark iDEC Guia De Inicio Rapido página 7

TROUBLESHOOTING
PROBLEM:
I can't hear any audio.
The unit is not turning on.
My iPod does not fit well in the dock.
The integrated controls will not control my iPod
SPECIFICATIONS
Dimensions:
Weight:
Audio Outputs:
Video Outputs:
Inputs:
Power:
Accessories:
FOR TECHNICAL SUPPORT AND ADDITIONAL INFORMATION ABOUT THIS PRODUCT, VISIT
3.5" (H) x 19" (W) x 4.7" (D)
3.125 lbs
Unbalanced RCA (x2)
Output Level: 8.2dBv +/-1dBv
THD: Less than 0.01%
S/N Ratio: Better than 85dBr
Frequency Response: Flat within 2dB from 20Hz to 20kHz
S-Video
Composite Video (RCA)
4G iPod and later (with dock connector)
AC IN, 100 ~ 240V
50/60 Hz, 17W
Stereo RCA Cable
Quickstart Manual
IEC Power Cable
Safety and Warranty Information
MANUAL VERSION 1.0
SOLUTION:
Check to make sure that your iPod is playing.
Make sure that the unit is powered on.
Make sure that the unit's audio outputs are connected to a speaker or
amplifier system and that the system is turned on.
Make sure that the power cable is connected to the rear of the unit and
that it is plugged into a live power source.
Use the iPod Universal Dock which was included with your iPod.
Your iPod may be in USB Mode. If the screen says "Do Not Disconnect",
then safely eject your iPod from the iTunes interface and hold the EJECT
button for 5 seconds to enter Direct Mode. If the screen does not say
"Do Not Disconnect", then just hold the EJECT button for 5 seconds.
6
WWW.NUMARK.COM