Extensions; Wet And Dry Applications; Maintenance And Repairs - Nilfisk cfm T26 Plus Manual De Instrucciones

T26 Plus - T48 Plus - T63 Plus

Extensions

If an extension cable is used, make sure it is suitable for the
power input and protection degree of the vacuum cleaner.
The vacuum cleaner's power socket must be protected
by a differential circuit-breaker with surge current
limitation, that shuts off the power supply when the
current discharged to the ground exceeds 30 mA for
30 ms or an equivalent protection circuit.
Never spray water on the vacuum cleaner: this could
be dangerous for persons exposed and could short
circuit the power supply.
US
C386
WARNING!
WARNING!

Wet and dry applications

The supplied filters and the bag (if applicable) must be
installed correctly.
WARNING!
Comply with the safety regulations governing the
materials for which the vacuum cleaner is used.
WARNING!
If the version for liquids is used:
■ Make sure the liquid level sensor is working
correctly before vacuuming liquids.
■ If foam forms, turn off the vacuum cleaner
immediately and empty the container.
■ Warning: Switch off the vacuum cleaner
immediately if foam or liquid leaks out.
■ Regularly clean the liquid level limiting device
and check to make sure that there are no signs of
damage.
■ Warning: dirty liquid vacuumed up by the vacuum
cleaner must be considered conductive.
WARNING!
Always vacuum a mix of water and air, to avoid
overloading the motor of the vacuum unit.

Maintenance and repairs

WARNING!
Disconnect the vacuum cleaner from its power
source before cleaning, servicing, replacing parts or
converting it to obtain another version/variant, the
plug must be removed from the socket.
■ Carry out only the maintenance operations
described in this manual.
■ Use only original spare parts.
■ Do not modify the vacuum cleaner in any way.
Failure to comply with these instructions could
jeopardize your safety. Moreover, such action would
immediately void the warranty of the device.
WARNING!
Contact manufacturer's technical service or sales
network for maintenance operations not described in
this manual.
6
[ NOTE ]
02/2013