Care And Storage - SATA HRS Instrucciones De Servicio

Operating Instructions SATA HRS
EN
For version with flow control
■ Screw the guide sleeve [1-19] with counter nut [2-20] and flow control
nut [1-21] into the gun body [3-9].
10.4. Replace the inlet valve
Remove the inlet valve
■ Unscrew the pressurized cup [1-4] / [1-7] / [1-13]; in doing so, the pres-
surized cup spray gun is also vented at the cup thread.
■ Unscrew the inlet valve [3-8] out of the gun body [3-9].
Mount the inlet valve
■ Screw the inlet valve [3-8] into the gun body [3-9].
■ Screw the pressurized cup [1-4] / [1-7] / [1-13] onto the gun body.

11. Care and storage

11.1. Storage
Attention!
Physical damage from incorrect storage
Strong sunlight and excessively high storage temperatures damage the
plastic pressurized cup.
→ Protect the plastic pressurized cup from strong sunlight.
→ Do not store the plastic pressurized cup at temperatures above
50 °C.
→ Do not store gun in filled state.
→ Keep the gun in cleaned, dried and completely emptied state.
11.2. Clean pressurized cup spray gun and wand
Warning!
Risk of injuries from components coming loose
Components may come loose unexpectedly when working on the pres-
surized cup spray gun while this is still connected to the compressed air
circuit.
→ Always disconnect the pressurized cup spray gun before any kind of
work and vent it completely.
122