General Operation Information; Whirlpool Operation - Jacuzzi LUXURY Serie Instrucciones De Instalación Y Operación

General Operation Information

All bathtubs manufactured by Jacuzzi Luxury Bath are
designed for "fill and drain," which means the bathtub
should be drained after each use and filled with fresh
water by the next bather. This is a health precaution,
as these bathtubs are not designed to hold water
continuously like pools or spas.
Two control panel types are available for the Luxury
Whirlpool series. Refer to details below:
•
J4 Luxury Electronic Control Panel:
Operational instructions for this panel is listed
below.
•
Optional J5 Luxury LCD Control Panel:
Operation instructions for this panel are outlined in
the supplemental guide provided in your warranty
pack. Refer to this document for complete operation
details (P/N GU47000).
Close the drain and fill the bathtub until water is at
least 1˝ to 2˝ (25mm to 51mm) above the highest jet
(see water line indicated in the illustration). Do not turn
on the whirlpool system at any time if the jets are not
completely immersed in water. Running the whirlpool
system when there is insufficient water in the bathtub
could result in water spraying outside the bath area.
Running the whirlpool system without water will damage
the recirculating pump.
When exiting the bathtub, the water level will drop
below the jets which could result in water being
sprayed out of the unit. To prevent this, you must
turn unit OFF before exiting bathtub.

Whirlpool Operation

ON: Press the jet button once to turn the whirlpool jets
ON.
The whirlpool motor will be on high speed. The indicator
lights at left will illuminate brightly.
OFF: Press the jet button a second time to turn the
whirlpool jets OFF.
If in chromatherapy lighting mode (indicator lights
to the left of the jet button are dim), you will need to
press jet button once to resume whirlpool operation
mode and then a second time to turn the whirlpool
power off.
Page 16
Main Menu
www.jacuzzi.com
Luxury Whirlpool Bath
J4 Control Panel
POWER
J5 Control Panel
Fill to at least 1˝ to 2˝
above highest jet
Jet
Installation and Operation