Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
6.
Ripping cut
WARNING:
Fig. 25
7.
Plunge cut
WARNING:
*
Never secure the lower blade guard in a raised position. Never move the saw
backwards when plunge cutting. This may cause the saw to raise up off the
work surface which could cause injury.
*
To avoid serious accident, ensure the trigger switch is on the OFF position,
and disconnect the plug from the receptacle before any adjustment.
*
Never tie or wedge the lower blade guard in a raised position.
Trigger switch
Auxiliary handle
Lower blade guard
lifting lever
(6) Holding the saw in position, with the blade not contacting the work piece surface, pull the
trigger switch.
(7) After the saw has reached full speed, gradually lower rear end of the saw until its base plate
rests on the work surface.
28
* To avoid serious accident, ensure the switch is OFF position, and
disconnect the plug from the receptacle before any adjustment.
* To avoid serious accident, make sure that the rip fence does not
touch the saw blade before use.
Rip fence
Fig. 26
Ripping means to cut wider boards into narrower
strips – cutting grain lengthwise. Therefore, it is
recommended to use the metabo HPT rip fence
(optional accessory, refer to page 15) to provide the
support and cut boards into the same width.
(1)
Mark the desired cutting area clearly with
lines all side. (See Fig. 26)
(2) Set
depth
material to be cut.
(3) Push the lower blade guard lifting lever all
the way back, so the blade is exposed as
shown in Fig. 26.
(4)
Tilt the saw forward and align the guide
notch with the pre-marked guide line.
(5) Release the lever. When the lower blade
guard contacts the workpiece surface, it
will be in the proper position to open freely
when cutting is commenced.
adjustment
according
to
Publicidad
Tabla de contenido
