Approvals; Quick Install Tips - Grundfos ALPHA Serie Instrucciones De Instalación Y Funcionamiento

12.1 Approvals

3191277
FCC Sections:
Section 15.19 (a) 3:
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
Section 15.21:
Any changes or modifications to this equipment
not expressly approved by the party responsible
for compliance could void the user's authority to
operate this equipment.
Section 15.105 (b):
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of
the following measures;
• Reorient or relocated the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Canadian EMC Standard:
ICES-003
This Class B digital apparatus complies with
Canadian ICES-003.
10

13. Quick install tips

1. To insure proper air venting of your system,
place Alpha in Fixed Speed III mode until all
air has been removed. Isolating zones during
this process will ensure proper air removal.
2. For balancing manifold zone(s) applications,
utilizing Constant Pressure mode 1 or 2 and
only one zone at a time during balancing will
ensure proper flow rate to each zone.
3. Always review your boiler minimum flow
rate requirements if utilizing Alpha as a
primary pump. Select one of the fixed speed
modes for boiler primary pump applications.
4. In general, for maximum energy savings and
comfort level, start with the AutoADAPT™
mode.
5. You may change hydraulic selection while
pumping. No permanent damage will occur. In
fact, Grundfos encourages testing the various
hydraulic modes with your hydronic system to
ensure maximum energy savings and comfort
level.
6. Zone panel control applications — when there
is a call for heat and power has been sent to
the Alpha pump, the Alpha will remember and
restart from the last duty point and hydraulic
mode.
Subject to alterations.