Chain And Bar Lubrication; Hydraulic Oil Information And Safety Requirements During Operation - SPARKY TV Serie Instrucciones De Uso

WARNING: The chain life depends mainly
WARNING:
down.
Screw the chain tensioning ring (10) clockwise until
ing. (Fig.5a)
bar in its centre. This is performed by using one
hand to raise the chain against the weight of the ma
chine. (Fig.5b)
then tighten the locking knob (11) again.
In cases where the loosened chain needs to be ad
adjust the tension and tighten the bar retaining knob
accordingly.
NOTE: If the chain rotates hardly on guide bar or if it
NOTE: If the chain rotates hardly on guide bar
smoothly.
Check the tension regularly because the chain tends to
cools down.

CHAIN AND BAR LUBRICATION

WARNING:
WARNING:
lubricating oil. Running the chain saw dry or with too
8
EN
Adequate lubrication of the saw chain during cutting
operations is essential to minimize friction with the
guide bar. The chain saw is equipped with an automatic
amount of oil to the bar and chain.
Filling the oil tank (Fig.6)
1. Place the chain saw on any suitable surface with the
oil tank cap (13) facing upward.
Unscrew the tank cap.
3. Add chain saw oil until the tank is full.
and tighten it.
WARNING: It is important to use only the recommended
CAUTION!
chain of lubrication.
NOTE: Your chain saw is equipped with an automatic
oiler system and which is the only source of lubrication
for the bar and saw chain.
Hydraulic oil information
and safety requirements
during operation
Product name:
General features:
Use:
Potential health hazards:
laboratory conditions. Under normal conditions of in
tended use this product does not pose a risk to health.
irritation.
First-aid measures:
utes. Get medical attention if irritation occurs.
with soap and water. Get medical attention.
tention.
Harmful if swallowed. Wash hydraulic oil from your
Notes to physician: Cure according to the symptoms.
Extinguishing media:
cals and water fog.
Extinguishing method: Spray.
Combustion products:
TV 1835 • TV 2040 • TV 2245