Operating Instructions; Prior To Initial Operation; Starting The Chain Saw - SPARKY TV Serie Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 61
position products in the case of incomplete combustion.
Water.
Measures against accidental release:
Wear appropriate personal protec
leaking container and seal tightly for proper disposal.
Handling and storage:
Do not store in open or unlabeled containers. Store in
pour) and can be dangerous. It is forbidden to pressur
Exposure control / Personal protection:
trations below the exposure guidelines/limits.
clothing and shoes. Wash hands with water an use cos
metic to protect

Operating instructions

ing current mains only. It is double insulated according
to EN 60745 and IEC 60745 and can be connected to
grounded or not grounded sockets. This power tool is ra

PRIOR TO INITIAL OPERATION

data of the power tool.
Make sure that the cord and the plug are in order. If the
to be done by the manufacturer or his agent in order
WARNING: switch off and unplug the power
In case the work area is remote from the power
Use extension cords for outdoor use and marked
accordingly. Always fully unwind the extension cord
drum.
It is recommended when operating outdoors and in
premises with high humidity to use a residual current
30 mA.
Original instructions

STARTING THE CHAIN SAW

NOTE: It is not necessary to maintain pressure on the
STOPPING THE CHAIN SAW
The chain saw will stop automatically when the switch
trigger (4) is released. To restart the motor press the
(4).
CHAIN BRAKE FUNCTIONAL TEST
The chain brake is a safety mechanism actuated through
immediately.
The functional test should be carried out at regular in
chain brake testing is to reduce the probability of injury
due to kickback.
Check the chain brake before starting to operate the
ing maintenance.
NOTE: The motor will not start if the chain brake is in the
engaged position.
CAUTION! The chain brake should not be used for start
ing and stopping the saw during normal operation.
3. Plug the machine into the supply source.
for extension
4. Grasp the front handle with your left hand (do not
or extension cords
5. Grasp the rear handle with your right hand. Thumb
gaged. The motor will not start if the chain brake is
in the engaged position. Disengage the chain brake
(Fig.7A)
cord hook. Gently tug on the cord to ensure that it
end of the extension cord into the tool power supply
cord. (Fig.8)
the front handle (do not hold the chain brake) and
the right hand holding the rear handle.
the switch trigger (4) and hold in this position.
(Fig.7B,C).
gaged. (Fig.7A)
encircle the handle.
9
EN

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Tv 1835Tv 2040Tv 2245

Tabla de contenido