Assembly - Sears Kenmore 148.16154210 Manual De Uso Y Cuidado

Attach the drip tray support to the beam and rear panel with four 3/16-24 x 3/8 in. screws as shown.
Note: Tabs at front attach beneath beam upper ledge.
Left Panel
Beam
Grill Head Assembly
First, lock the two rear casters of the grill cart.
Locate the gas pressure regulator and igniter wires under the grill head control panel. Carefully cut
the tie wrap(s) from the regulator hose. With the aid of an assistant, lift and place the grill head onto
the cart, making sure that the regulator hose and igniter wires hang down into the cart. Align the
corner holes at the base of the grill head with the holes in the corner tabs of the cart. Attach the grill
head to the cart with four 3/16-24 x 3/8 in. screws.
WARNING: Do not lift grill head from sides. Grasp the grill head by the front control panel and
rear panel to avoid pinching fingers when lowering grill head onto cart.
Drip tray support
Rear Panel
18
3/16-24 x 3/8 in. Screw
Qty. 4
Right Panel
3/16-24 x 3/8 in. Screw
Qty. 4