Sears Kenmore 148.16154210 Manual De Uso Y Cuidado página 19

Connect the four burner ignition wires to the four sockets on the right side of the igniter. Connect the
remaining wire to the remaining open socket.
Place the ground wire through the slots on the side panel as shown below. Loosen one control panel
screw, install the ground wire onto the screw, and retighten it to make a good connection.
Ground Wire
Install the doors
For each door, insert the bottom hinge pin into the hole in the bottom panel. Push up the top hinge
pin located under the bottom of control panel to get it into the hinge hole in the door. If necessary,
loosen screws on bottom panel magnet housing and adjust and retighten so that doors close
securely.
Ground Wire
19