Psw Basic; Overview; Technical Data - Resol PSW Basic Manual De Uso

PSW Basic

1

Overview

The PSW Basic signal converter is used for connecting speed-controlled high-ef-
ficiency pumps with a PWM or 0-10 V control input to a controller without a
corresponding output.
• For solar and heating pumps
• PWM or 0-10 V output signal
• Inversion of the output signal possible
• Robust and dripping water protected housing
The PSW Basic pump signal converter converts the 230 V signal of the controller
to which a standard pump had previously been connected, into a signal that enables
speed control of a HE pump. 1 HE pump per signal converter connectable.
The following signal conversions are possible:
Input signal PWM PWM
Output signal
On / Off,
x
Burst / wave packet x
Leading-edge phase control x
Trailing-edge phase control x
Not suitable for heat pumps and DHW exchange controllers
16
0-10 V 0-10 V
inv. inv.
x x x
x x x
x x x
x x x

Technical data

Inputs: On / Off, bursts / wave packets, phase cutting
Outputs: PWM / 0-10 V
PWM frequency: 625 Hz +-15 %
PWM voltage: 11 V
Power supply: 220 ... 240 V~ (50 ... 60 Hz)
Supply connection: type Y attachment
Power consumption max. 1.5 VA
Mode of operation: 1.Y
Rated impulse voltage: 2,5kV
Functions: signal converter, converting a speed-controlled 230 V signal into a
PWM or 0-10 V signal
Housing: plastic
Mounting: Wall mounting
Protection type: IP65 / EN60529
Protection class: II
Ambient temperature: 0 ... 40 °C
Degree of pollution: 2
Dimensions: 80 x 80 x 53 mm