Hayward LPCUS11 Serie Manual De Uso página 10

Install Wiring using a Hayward Junction Box Transformer
Hayward offers pool/spa light transformers designed to fit into various manufacturer's junction boxes. Refer to the table on this page to determine which model
transformer will fit your type of junction box. These transformers are designed to power a single Hayward ColorLogic/CrystaLogic LED light. If more than one
light is installed, multiple junction box transformers must be used.
IMPORTANT: 300 watt (LPLUS11xxx) and 500 watt (LPWUS11xxx) CrystaLogic lights must be used with low voltage transformers rated 100 watts or
greater. Do not use with Hayward LRBUY11xxx and LTBUY11H65 Junction Box Transformers.
Run conduit from the junction box transformer to the pool/spa controller or switch box. Snake 3 wires through the conduit. Connect the ground wires to the
ground terminal connections inside the junction box. Use wire nuts to connect the field-installed wiring to the 120V side of the transformer and the Universal
ColorLogic/CrystaLogic LED light cord to the low voltage side of the transformer. Refer to wiring diagram below.
Switch
10
Junction Box
Transformer
Yellow low
voltage leads
Ground
Low voltage
to Universal
ColorLogic
LED Light
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
To Hayward ColorLogic
LED Light
120V
Black
(hot)
120V
White
(neutral)
Bonding
wire if plastic
conduit
120V from
pool controller
or switch