Description Of Operation - brennenstuhl L CN 110 IP65 Manual De Instrucciones

Operating Instructions
D
5. Guide the connecting cable through the cable gland and connect
it to the light's lustre terminal as shown in Fig. 2 (left image shows
10 W version, right image shows 30 W version and higher. N = blue
cable, earthing symbol = green / yellow cable, L = brown cable).
6. Make sure the cable is securely fastened in the cable gland.
7. Replace the cover of the terminal box. Make sure the gasket is
seated correctly.
8. Fasten the light to the wall bracket using the screws and nuts
included with the package. Set the light to the desired position
and tighten the screws.

DESCRIPTION OF OPERATION

(For Versions with a Motion Detector)
The light is equipped with an infrared sensor. It turns on automatically
whenever the sensor detects movement in its vicinity
Try not to aim the motion detector in the direction of swimming pools,
heater vents, air conditioners or objects which are subject to large
variations in temperature. Avoid pointing the motion detector at trees
or shrubs and at areas where pets like to move about.
Make sure when mounting the light that the motion detector is most
sensitive to things that move through its detection range from side
to side and least sensitive to things that move straight at the device.
ADJUSTING THE MOTION DETECTOR
There are three knobs on the underside of the light (see Fig. 3).
Setting the time (TIME):
Use the TIME knob to set how long the light remains on after the last
movement (between 10 seconds and 4 minutes). Turn the TIME knob
clockwise to increase the time span.
10
A_Chip_Leuchte_Stationaer_130701.indd 10
Chip LED Light
01.07.13 10:56