Safety Notes - brennenstuhl L CN 110 IP65 Manual De Instrucciones

Chip LED Light

SAFETY NOTES

1. The light must be installed and serviced by a qualified technician.
2. Always turn off the power supply before installing or servicing the
light.
3. The light must be properly earthed.
4. Do not use this light without properly attached gaskets!
5. LED lights are extremely bright! Avoid looking straight into an LED
light beam, as doing so could result in irreversible eye damage.
6. Damaged protective covers must be replaced with an original
Brennenstuhl protective cover before the light can be used again.
7. If the mains supply cable of the light is damaged it must be replaced
by a qualified technician in order to avoid risks.
MOUNTING AND CONNECTION TO THE POWER SUPPLY
1. Do not attach the light to a surface that is subject to vibrations.
2. Mounting position: If possible the light should be mounted using
the wall bracket. Lights with a motion detector must be mounted
as shown in Fig. 1.
3. Mark the position of the bore­holes that are needed to attach the
wall bracket and drill the required holes in the wall. Attach the
bracket to the wall using suitable screws.
4. Open the light's terminal box.
A_Chip_Leuchte_Stationaer_130701.indd 9
Operating Instructions
D
9
01.07.13 10:56