Description; Selector Switch; Keypad; Display - Metrix ASYC II Serie Manual De Instrucciones

Chapter II
2.

DESCRIPTION

This multimeter is one of the ASYC II (Advanced SafetY Concept, third generation) family,
designed for a high degree of user safety, maximum protection and a hitherto unrivalled
performance.
2.1.

Selector switch

It is a standalone, handheld professional measuring instrument, capable of measuring the
following quantities (accessed by the ten-position rotary selector switch) :
∗ AC voltages with AC (or RMS) capacitive coupling,
∗ AC voltages with AC + DC (or TRMS) direct coupling,
∗ DC voltages,
∗ AC currents with AC (or RMS) capacitive coupling,
∗ AC currents with AC+DC (or TRMS) direct coupling,
∗ DC currents,
∗ resistance values,
∗ continuity (with beeper),
∗ capacitance,
∗ diode threshold voltage,
∗ frequencies,
∗ duty cycles,
∗ dBm,
∗ temperature.
2.2.

Keypad

An ten-key keypad lets you :
∗ select the autoranging mode (RANGE key)
∗ freeze a value (HOLD key)
∗ measure fast peaks (Pk +/- key)
∗ set the measurement relative to a reference value (REL key)
∗ select a function derived from the main function, or switch on the multimeter again after it
has been shut down automatically (SEL/ON key)
∗ select time-domain measurements: frequency, duty cycle, (Hz key)
∗ select survey mode to detect minimum, maximum or average value (SURV key)
∗ expand the bargraph scale (ZOOM key)
∗ activate sending data to a printer (PRINT key)
∗ activate back lighting of the display unit (
2.3.

Display

The display shows (display backlight when required in poor lighting conditions) :
∗ clearly legible figures (14 mm high)
∗ a readout of the parameter being measured through a 34-segment bargraph
∗ perform 50 000-count measurements (high resolution)
∗ perform 5 000-count measurements (low resolution)
2.4.

Power supply

It is powered by a standard 9 V battery which provides approximately 500 hours of operation.
2.5.

Input terminals

Measurements are performed using two measuring leads supplied with the instrument connected
to input terminals 1, 2, 3 and 4, as indicated in §. 3.1.
Portable digital multimeter
key)
23