Maytag MED5620TQ0 Manual De Uso Y Cuidado página 11

4-wire connection: Direct Wire
IMPORTANT: A 4-wire connection is required for mobile homes and where local codes do
not permit the use of 3-wire connections.
Direct wire cable must have 5 ft (1.52 m) of extra length so dryer can be moved if needed.
Strip 5" (12.7 cm) of outer covering from end of cable, leaving bare ground wire at 5"
(12.7 cm). Cut 11/2" (3.8 cm) from 3 remaining wires. Strip insulation back 1" (2.5 cm). Shape
ends of wires into a hook shape.
(12, 7
When connecting to the terminal block, place the hooked end of the wire under the screw of
the terminal block (hook facing right), squeeze hooked end together and tighten screw, as
shown.
1. Remove center silver-colored terminal block screw.
Remove neutral ground wire from external ground conductor screw. Connect neutral
ground wire and place the hooked end (hook facing right) of the neutral wire (white or
center wire) of direct wire cable under the center screw of the terminal block. Squeeze
hooked ends together. Tighten screw.
......... C
A. [xterna/ ground conductor screw - Dotted line shows
position of NEU FRAL ground wire before being moved to
center silv_'r-color_'d terminal block screw.
B. C_'nter silver-color_'d terminal block scr_'\,v
C. Neutral wire (white or center wir_')
D. _/4" ( h 9 cm) UL listed strain reli_'f
E. Neutral ground wire