Level The Washer - Maytag MTW5600TQ1 Manual De Uso Y Cuidado

3. 2. Screw t heIocknut onto each foot t owithin 1"(2.5 cm) o fthefootbase.
Wrap thedrain hose t othelaundry tubleg, d rain standpipe orinlet h oses, withthe
beaded tiestrap. Push f astener intothenearest hole ill thebeaded tiestrap. See view
AorB.
1 "
(2.5 cm)
f
Screw the feet into the threaded holes at the front corner of the washer until the nuts
toucln the washer. Twist tlne feet to install.
NOTE: 13o not tighten the nuts until the washer is level.
If the washer faucets and the drain standpipe are recessed, put the formed end of the drain
hose into the standpipe. Tightly wrap the tie strap around the water inlet hoses and the
drain hose. See view C.
LEVEL THE WASHER
Properly leveling your washer avoids excessive noise and vibration.
Install the Front Leveling Feet
1. Prop up the front of the washer about 4" (10.2 cm) with a wood block or similar object.
[he block needs to support the weight of the washer.
4"
(10.2 cm)
A. Threaded holes for f_et
/
4. Tilt the washer back and remove the wood block. Gently lower the washer to the floor.
Steps in Final Location
1. Slide the washer to its final location.
2. Tilt the washer forward until the rear of the washer is at least 4" (I 0.2 cm) off the floor. You
may hear the self-adjusting rear feet click into place. [.ower the washer to the floor.
4"
(10.2 era)
A. 5_,lf-adjusting f_'_'t
I