Electrical Requirements; Electrical Shock Hazard - Maytag MTW5600TQ1 Manual De Uso Y Cuidado

Lavadora automatica
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

lb avoid s iphoning, nomore than 8"(20.3 cm) o fdrain hose s hould b einside t hestandpipe.
Secure drain hose withbeaded tiestrap.
ELECTRICAL
REQUIREMENTS
39"
(99 cm)
Laundry
tub drain
system
(view
C)
The laundry
tub needs a minimum
20 gah (76 1.) capacity.
The top of the laundry
tub must be
at least 39" (99 cm) above the floor
and no higher than 96" (244 cm) from the bottom
of the
washer.
Floor
drain
system
(view
D)
The floor drain
system requires
a siphon
break that may be purchased
separately.
See "lL_ols
and Parts."
The siphon
break must be a minimum
of 28" (71 cm) from the bottom
of the washer.
Additional
hoses might be needed.
lo avoid siphoning,
no more than 8" (20.3 cm) of drain
hose should
be below
the top of the
wash tub. Secure drain hose with
beaded
tie strap.
C
D
Electrical
Shock Hazard
Plug into a grounded
3 prong outlet.
Do not remove ground prong.
Do not use an adapter,
Do not use an extension
cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
A 120 volt, 60 Hz., AC only, 15- or 20-amp,
fused electrical
supply
is required.
A time-
delay fuse or circuit
breaker
is recommended.
It is recommended
that a separate
circuit
serving
only this appliance
be provided.
This washer
is equipped
with
a power
supply
cord
having
a 3 prong grounding
plug.
lo minimize
possible
shock hazard,
the cord must be plugged
into a mating,
3 prong,
grounding-type
outlet,
grounded
in accordance
with
local codes and ordinances.
If a
mating outlet
is not available,
it is the personal
responsibility
and obligation
of the
customer
to have the properly
grounded
outlet
installed
by a qualified
electrician.
If codes permit
and a separate
ground
wire is used, it is recommended
that a qualified
electrician
determine
that the ground
path is adequate.
Do not ground
to a gas pipe.
Check with
a qualified
electrician
if you are not sure the washer
is properly
grounded.
Do not have a fuse in the neutral or ground
circuit.
6

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido