Troubleshooting - Franklin Chef FWC36 Manual Del Usuario

Wine Cellar Troubleshooting
Wine cellar does not turn on
Not plugged in.
Fuse blown or circuit breaker tripped
Noise or vibration
Check that unit is level. If not, use leveling leg.
Wine cellar is too warm
Check that door is properly sealed.
To change the temperature, follow the steps in the Operating Your Wine Cellar section of this
manual.
LCD displays "PROBE ERROR – E"
This message is an ALARM MODE indication. The LCD displays "PROBE ERROR" on the
left and "E" in the middle when the thermostatic sensor has malfunctioned. When this hap-
pens, the cellar first stops working for 25 minutes, then turns ON for 30 minutes and OFF for
20 minutes automatically and continuously. Contact your authorized service facility for sen-
sor replacement.
LCD displays "LOW TEMP"
This message is an ALARM MODE indication. The LCD displays "LOW TEMP" on the left
and "L" in the middle. It indicates that the actual temperature is much lower than your set
temperature and that the magnet valve may not be functioning properly and should be
replaced. Contact your authorized service facility immediately.
LCD displays "HIGH TEMP"
This message is an ALARM MODE indication. The LCD displays "HIGH TEMP" on the left
and the actual temperature reading in the middle. It indicates that the actual temperature is
much higher than your set temperature. Possible causes are:
• The door may not be fully closed.
• There may not be sufficient air space on the sides and top of the unit.
• The refrigerant may have leaked.
• The magnet valve may not be functioning properly and should be replaced.
If you are certain that neither the door nor the lack of free space around the unit is the cause
of the problem, contact your authorized service facility immediately.
7