Power-Mate - Sears Kenmore 11659512992 Manual Del Proprietário

Always follow all safety precautions when
cleaning and servicing the POWER-MATE'_fl
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the unit,
Failure to do so could result in elec-
trical shock or personal injury from
cleaner suddenly starting.
1. Remove light
cover by pressing
in and lifting both
sides as shown
Push in
And Turn _=_
2. Push in and turn
bulb counterclock-
wise to remove
3. Replace the bulb,
Bulb must not be
higher than 15 Watts,
Close light cover until
it snaps in place,
NOTE: See PARTS AND FEATURES for
Bulb #o
Disconnect cleaner from electrical outlet.
Check and remove hair, string and lint build-
up frequently in the POWER-MATE
TM
brush
and brush support areas. If build-up
becomes excessive, disconnect POWER-
MATE
TM
from wand and follow the steps
below. Instructions can also be found under
the light cover°
TO REMOVE BELT:
1. Remove light
cover and light
bulb as shown
under LIGHT
BULB
CHANGING.
2. Unscrew the
POWER-
MATE
TM
cover
screws.
3. Turn
POWER-
MATE
TM
over
To remove
cover, insert 1
screwdriver at
cover tabs on
both sides and
twist to
release tabs_
4. Turn POWER-
MATE
TM
right
side upo Press
handle release
pedal and lower
the swivel Tilt
cover forward
from back until
front snaps free
I4