Electrical Connections - Bossini AQUAVOLO I01555 Instrucciones De Montaje

Installazione - Installation - Installation - Installation - Instalación - Установка
the supply of a control keyboard with the cable of the desired length.
INSTALLATION
-Temporarily fix the wall support plate (1) by screwing the water inlet connector (2) to the water supply point
(Fig. D).
-Make sure the support plate is perfectly horizontal to the floor using a level. Use a pencil to mark the six holes for the fastening
screws (3). Then remove the water inlet connector (2) and the wall support plate (1) (Fig. D).
- Drill the six holes using a 8 mm drill bit, and insert the wall plugs. (Fig. E).
- Firmly fix the wall support plate (1) by screwing the water inlet connector (2) and the six screws into the wall (3) (Fig. F).
-Insert the showerhead (4) and screw the suitable fastening dowels (5) already mounted onto the support plate. Then fix the
open end of the gas springs (9) onto the lower part of the support plate with the suitable screws (6) (Fig. G).

ELECTRICAL CONNECTIONS

-
Connect the electrical cables A and B, of the keyboard (13) and the music player (15) respectively, to the corresponding control
unit inputs of the electronic components group (11), see (Fig. G and H).
- Connect the cable C from the transformer (14) whit the connector with fuse (19) (Fig. H).
-Fit the group (11) onto the wall support plate (1) (Fig. I).
-Apply the support cover (7) carefully, to avoid damage to the WideRain spray nozzles, until full adherence to the wall (Fig. L) .
- Tightly fix the cover (7) onto the wall support with the special screws (8) (Fig. M).
- Remove the protection film (10) from the showerhead upper and lower surfaces (4) (Fig. M).
Electrical system : Technical specifications
1. Electrical supply ..........................................................
Electricity consumption 0,1°
2. Supply cable..................................................................
3. Box with transformer and filter ...............................
4. Protection grade .........................................................
5. Electronic board.........................................................
6. Control keyboard........................................................
7. Safety mark.................................................................
8. Speakers ..................................................................
9. Jack audio connector ............................................
10. Aquavolo ..................................................................
EC
Electrical systems in compliance with national and international regulations applied, must be made by qualified
technicians. A bipolar switch on the electrical supply (230V) must always be provided and it must be accessible in order to
enable the showerhead switching off in case of malfunction.
220/230V ~ – 50/60 Hz – 20va max
protection class II
bipolar 1mm² cross section
It must have minimum outer diameter ø 5 mm and a max outer diameter ø 13 mm.
(not included in the package)
(IP56) 7V ~/ 230V~ – 50/60 Hz for installation outside
the safety area (in compliance with DIN VDE 0100
standard, part 10 – CEI 64/8 Italian regulation)
IP x 5
IP66/IP67
IP65
EC
4led RGB max 3 watt
standard stereo 3,5mm
4led RGB max 3 watt
19