Polisher Safety Warnings - SPARKY PMB 1200CE Instrucciones De Uso Originales

b) Do not use the power tool if the switch
does not turn it on and off. Any power tool
that cannot be controlled with the switch is
c) Disconnect the plug from the power
source and/or the battery pack from the
power tool before making any adjust-
ments, changing accessories, or stor-
ing power tools. Such preventive safety
measures reduce the risk of starting the
d) Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
e) Maintain power tools. Check for mis-
alignment or binding of moving parts,
breakage of parts and any other condi-
tion that may affect the power tool's op-
eration. If damaged, have the power tool
repaired before use. Many accidents are
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to bind
g) Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to be
performed. Use of the power tool for op-
erations different from those intended could
5) Service
a) Have your power tool serviced by a
tical replacement parts. This will ensure
that the safety of the power tool is main-
Polisher safety
warnings
Safety Warnings Common for Sanding
Brushing or Polishing Operations with
felt wheels, polishing sponges, lambs-
wool bonnets and felt wheels with
a) This power tool is intended to function
Original instructions
as a polisher or machine for cleaning
surfaces with a wire brush. Read all
safety warnings, instructions, illustra-
this power tool. Failure to follow all in-
structions listed below may result in electric
b) Operations such as grinding or cutting-
off are not recommended to be per-
formed with this power tool. Operations
for which the power tool was not designed
may create a hazard and cause personal
c) Do not use accessories which are
mended by the tool manufacturer. Just
because the accessory can be attached to
your power tool, it does not assure safe op-
Never mount circular blades or grinding
wheels for angle grinders.
Use only accessories appropriate for
the processed material and the rotation
speed.
d) The rated speed of the accessory must
marked on the power tool. Accessories
running faster than their rated speed can
e) The outside diameter and the thickness
of your accessory must be within the
capacity rating of your power tool. In-
correctly sized accessories cannot be ad-
f) Threaded mounting
must match the grinder spindle thread.
the arbour hole of the accessory must
- Accessories that do not match the mount-
ing hardware of the power tool will run out
of balance, vibrate excessively and may
g) Do not use a damaged accessory. Be-
fore each use inspect the accessory
such as backing pad for cracks, tear
or excess wear, wire brush for loose or
cracked wires. If power tool or acces-
sory is dropped, inspect for damage or
install an undamaged accessory. After
inspecting and installing an accessory,
position yourself and bystanders away
from the plane of the rotating accessory
and run the power tool at maximum no-
load speed for one minute. Damaged ac-
-
of accessories
5
EN